HVAC Services In Oklahoma City, OK

Technician arrived on site to perform a routine heating safety tuneup, checking all electrical components for proper functioning and efficiency, checking overall safety, limit switches and carbon monoxide for safety procedures and making sure that the heater works throughout the winter season found the flame sensor faulting out told the customer about this part as a preventative

Floor furnace tuneup today. Cleaned the furnace and checked for carbon monoxide.

This House hasn't been heating and cooling properly after running my camera down the duct work there was so much blockage from debris.

Today on a Goodman unit I performed a Gas furnace safety check. After thoroughly going through the unit I noticed dog hair everywhere, so I put my camera down the return vent and it was a lot of dog hair. Keep those ducts and vents clean for the overall performance of the unit.

Arrived on site to do a routine single system heating maintenance tuneup, checking all electrical components for proper efficiency and safety checking all safety components doing a CO test to check for dangerous gases being admitted into the home found a couple parts that could preventatively be changed to keep the system running through the winter months this seasongoing to recommend to change the igniter in the flame sensor

Today, duct cleaning and sanitizing were performed to enhance indoor air quality and improve the efficiency of HVAC systems. This maintenance task helps remove dust, allergens, and contaminants from the ducts, potentially leading to better airflow and a healthier environment. If any specific issues or improvements were noted during the process, they could further inform future maintenance decisions.

I was dispatched to a Lennox 13/80 system for a no-cooling call. Upon arrival, I found a broken drain line connection on the coil. I put together some solutions to help the customer get him fixed up.

Arrived on site to repair a whirlybird roof flashing, that was damaged due to high winds. Had to get it done before the big storm. To not let rain water damage the home.also made repairs on her Flame sensor safety device, and hot surface ignition system.

Technician arrived on site to install a new hot service igniter and flame sensor for our customer to prevent her from having any breakdowns or losing her heat during the winter months. System is working correctly at this time.

I am a skilled professional that works for a Triple Play Home Services company. I recently completed a furnace safety check on a Goodman 80% furnace. This involved verifying the venting connections, testing all the controls within the system, inspecting all motors and motor controls, checking the wiring, and performing a carbon monoxide test, which resulted in a reading of 0ppm.

Technician arrived on job site to perform routine heating safety inspection checking over all electrical components limit switches, safety devices temperature limit switches CO test, inducer and blower amps flame sensors igniters for the proper functioning and safety of our customer. System is running safely and efficiently found a flame sensor fault. Going to recommend to replace the flame sensor as a preventative maintenance for our customer this winter season.

I recently completed a job as an HVAC contractor tech where I inspected two Amana 96% systems. I verified that the venting had proper fall and clearances, that all safety and control devices were working properly, that there was no biological growth, that the heat exchangers were inspected, that all motors and motor controls were tested, and that carbon monoxide was tested and found to be at 0 ppm. I also provided solutions to help keep the systems running throughout the season.

Arrived on site to perform a single system heating maintenance checking over all electrical components claim sensors igniters blower motors in inducer fan motors for safety and efficiency found igniter and flame sensor going out causing her heating to stop running while I was here thankfully we are getting those parts fixed, so her heater will work correctly this winter season

I recenty completed a fall furnace tune-up for a 14-year-old Carrier system. The tune-up included a 21-point inspection, which included checking all safety controls, inspecting the heat exchanger, and ensuring the stability of the motors. No natural gas leaks were present, and carbon monoxide was not detected. When complete went over inspection report with customer and made customer aware along system operation and put together some solutions to help system run smooth thro the winter

Today, wecompleted a duct cleaning process followed by sanitizing the system. This work is aimed at enhancing air quality and improving the overall efficiency of the HVAC system

Performed service on Samsung inverter mini split heat pump 1 ton, located in e Wilshire blvd, system is operating as should discovered biological growth inside system and out together some solutions to help clean the quality of air inside the space being served

Today, a safety check was performed on a furnace. This process is crucial for ensuring the furnace operates efficiently and safely. If there were any specific findings or issues during the check

No cool service cool on 20 year old concord 10 seer system , system has refrigerant contamination, went over diagnosis with customer and put together some solutions to help solve her problems today

Today in Del City I performed a gas furnace safety check on a fairly new unit. So I made sure all the electrical components were up to manufacturer specifications and that no carbon monoxide was present in the home.

Routine gas furnace safety check on a Lennox unit. The customer had their thermostat on auto to go back and forth from cool to heat however what they didn't notice that in heat mode the blower motor wasn't coming on however it was come on in cooling so they thought all was well luckily they called for a tune-up and we found the problem before it got too cold.

Arrived on site for a hvac split system. Estimate. Customer just bought the house and wants to see the product line of equipment available through triple play home service

Arrived on location to do a routine heater safety inspection on a Diakin Fit Dual fuel system. Heat pump & Natural gas fired heat options. Checked all electrical motors, safety procedures, temperature limit switches and CO. Found heater to be safe and efficient for our customers this upcoming winter season.

Installed 2 portable A/c units for our customers while waiting for a fan motor to come in for replacing.

Today I had a routine gas furnace safety check on a Trane unit. I checked it for carbon monoxide and checked all the duct work along with all the electrical components making sure this home will be warm and safe for the winter.

Diagnostic on 80% comfort maker unit reason for visit, faulty air circulation system in main furnace unit , has had issues with giving stat, and was fixed but unit still not coming on, after diagnosing went over diagnosis with customer, explaining everything going on with system and what’s to come.